- Make Beneteau
- Model Antares 9.80
- Year 2003
- LOA 32ft/10m
- Class Semi-Displacement
- Hull Glass Reinforced Plastic
- Engine Twin Diesel
- Drive Shaft Drives
- Layout Flybridge
- Berths 4
- Cabins 2
- Ancasta Ref 34101
- Name Salar
Beneteau Antares 9.80 For Sale | 2003
Flybridge motor cruiser built by Chantiers Beneteau France
CONSTRUCTION
Blue GRP hull with white deck and superstructure
Teak cockpit and flybridge steps
Bow thruster
Deep V-hull
Twin rudders
Sliding cockpit system to enlarge the cockpit.
L.O.A - 9.95M (32' 10")
L.W.L - 9.56M (31' 3")
BEAM - 3.42M (11' 0)
DRAFT - 0.85M (2'79")
AIR DRAFT: 4.30M (14' 1")
All above firgures are approximate
SALOON
U-shaped dinette in blue upholstery to port with table.
Storage lockers to starboard
Cherry wood joinery.
Headroom 1.90m (6' 3") throughout.
BERTHS
Forward cabin with double berth, hanging locker, storage unit and shelving.
Second cabin to starboard with twin bunks and bedside locker.
HEADS
Heads compartment with Jabsco w.c, handbasin, shower, mirror and locker.
GALLEY
Galley area forward of the dinette to port with:
Eno two burner gas hob, oven and grill.
Front opening 80L fridge.
Stainless steel sink.
Engines serviced annually
Shaft drive to propellers.
Approx engine hours run - 650hrs
Trim tabs
Bowthruster
Bowthruster rebuilt in 2023 by Owner.
Engine Rebuild taken place on both Nanni Nahm Diesels 4380 TDI. Works were carried out by Adrian Cronk Marine on site at Chichester Marina where berthed.
ELECTRICS
4X Engine and domestic batteries
Charged by engine alternator and battery charger
Galvanic isloator
Shore power and cable
TANKAGE
2X 320 litre fuel tanks
1X 220 litre water tank
1X 80 litre holding tank
WATER SYSTEM
Pressurised hot and cold water system.
Water heated by engine calorifier and immersion heater.
2X Plastimo compass.
Raymarine ST60+ multifunction on flybridge.
Raymarine C80 colour chartplotter with radar scanner at lower helm.
EPIRB- 2014.
VHF (DSSC) radio.
Autopilot.
Horn.
Navigation lights.
GROUND TACKLE
Anchor, chain & warp.
Electric anchor windlass.
GENERAL EQUIPMENT
1X manual bilge pump.
1X electric bilge pump.
Guardwire, puchpit & pulpit.
Rear cockpit enclosure.
DVD.
Warps and fenders.
Radio/CD/MPR player with internal and exterior speakers.
Boarding ladder.
Engine spares.
Carbon monoxide & gas detector.
Ancasta are acting as brokers for the vendor who is not selling in the course of business unless otherwise stated. These details are prepared from information provided by the vendor and are intended only as a guide to give a fair description of the vessel but their accuracy cannot be guaranteed and they do not constitute part of any contract.
A prospective buyer is strongly advised to check the particulars and to have the vessel fully surveyed by a qualified marine surveyor. Details are supplied on the understanding that all negotiations shall be through Ancasta brokerages. This vessel is offered subject to prior sale, price change or withdrawal without notice. Please Note: where the vessel’s status shows as “Preliminary”, details of the vessel have not yet been confirmed by the Vendor.
Don't have an account? Register
Broker Comments
Beneteau Antares 9.80 built in 2003, this is a fantastic family boat. Four berths in two cabins, a great sized fly-bridge and cockpit as well as easy access to the foredecks. This Antares 9.80 is fitted with Twin Nanni TDI 200hp Diesels and a bow thruster making her ideal for both inexperienced and seasoned motor boat owners.Works completed since Ownership. Coppercoat applied in 2017 by Ocean Marine. 23/07/2017. Engine Rebuild taken place on both Nanni Nahm Diesels 4380 TDI. Works were carried out by Adrian Cronk Marine on site at Chichester Marina where berthed. 2024 Sony Upgraded stereo system to include fusion marine speakers with subwoofer in Saloon. 2020 Upgraded charger unit 2024 Upgraded LED lights internally 2024 Carbon fibre works completed by owner in 2022. Out on the water in June this year and went back in the Water in May after works below carried out Works carried out: -Antifouled on Prop and Stern Gear. Scuffed up the Copper coat to reactivate and new anodes. -Full compound and polish which was finished with a ceramic coating.